Publicidad
5
Install mortise chassis
5a
FOR ELECTRIFIED LOCKS ONLY: Route the wire harness and wiring into the prepared channel before proceeding
with installation.
5b
Attach cable end(s) to spool(s).
Feed the cable through the spool.
Fit the cable end into the cable hole.
Check that the cable is properly
routed through the spool.
For 2-point latch only:
The bottom spool access is on the
opposite side of the mortise. Turn the
mortise over to access the bottom
spool.
5c
Turn spool to move cable end fitting.
Turn the cable spool screw(s) clockwise at top and bottom (if applicable) of the mortise chassis to rotate the spool until the cable end
fitting is beneath the mortise cover. Do not turn counter-clockwise.
Check the cable end
fitting(s). The end fitting(s)
should be under the
mortise cover.
Cable must be positioned
over the wire retainer.
5d
Install the top and bottom spool covers on the mortise chassis.
Spool
covers must
be installed to
protect the lock
from debris.
Top spool
cover
Cable end
Top spool
shown
Cable end
Wire retainer
Cable must
be positioned
over the wire
retainer.
Check to be sure the cable
is properly fed through the
spool cover slot.
Bottom
spool cover
#6 x ¼"
7
Publicidad
Capítulos
