Install Latch(Es) - Schlage LM9200 Serie Instrucciones De Instalación

3

Install latch(es)

3a
IMPORTANT! Check lock handing before installation.
LM9210 does not use a lock handing screw.
To change handing:
Remove the lock
handing screw from
one side of the
chassis and install it
on the opposite side.
The lock handing
screw should always
be on the interior
(door stop) side of the
door.
3b
FOR ELECTRIFIED LOCKS ONLY: If necessary,
move EL/EU switch to desired position before
installation.
3c
Confirm top latch is marked for LM9200 LOCK ONLY,
then remove label.
EL/EU
switch
ATTENTION:
FOR USE WITH
LM9200 LOCK ONLY
3d
Connect cable end fitting(s) to latch(es).
Top latch: Pull cable link down. Slide cable end into cable link.
Bottom latch: Bend cable slightly to access cable link, then install.
Top latch
Cable
link
Pull
L Refer to illustrations to identify top and bottom latches.
L For 2-point latches, the bottom cable is black.
3e
Set the door on sawhorses with the top notch cutout (door stop
side) facing down.
TOP
Bottom latch
For 2-point latch only
Bend
Cable
link
BOTTOM
5