Publicidad
3f
Feed the cable(s) through the door.
The ends of the cables will rest in the mortise pocket.
Insert the top latch into the door.
T O
P
Check handing. The top latchbolt should swing toward the
notch cutout side of the door.
Insert the bottom latch into the door (2-point latch only).
B O
Check handing. The bottom latchbolt bevel should face
opposite the notched cutout side of the door.
3g
Secure the latch(es).
Top
Wood
#25 drill, pilot 1Z\x" deep x4
Metal
#10-24, UNC-2B
Notch
cutout
O M
T T
Bevel faces
opposite notched
side of door
Bottom (for 2-point latch only)
Wood
#25 drill, pilot 1Z\x" deep x4
Metal
#10-24, UNC-2B
3h
Perform cable binding check at the mortise pocket.
Pulling on top cable should
lock and unlock the top latch.
Cable adjustment points
L Adjustment points referenced in
the remainder of this instruction
are shown here.
4
Check cable spool(s) position.
Check spool(s) to be sure they are in unretracted state (toward top
and bottom of the mortise chassis).
If the spool cable hole is not visible or only partially visible,
rotate the cable spool screw with hex wrench to reveal the
cable hole.
L See "Cable adjustment
points" above for an
illustration of the spool
screws.
B\cx"
Pulling on bottom
cable should retract
the bottom latch
(2-point latch only).
Top cable
spool screw
Bottom cable
spool screw
Cable hole
6
Publicidad
Capítulos
