IMPORTANT: Ensure power status icon (see Fig. 7) indicates power is connected.
If not, check that cord is plugged in completely. (See Chapter 10 - Troubleshooting
for more information.)
IMPORTANT: While the concentrator is powered from the DC power supply and
operating in continuous mode at setting 2, the battery will not charge.
IMPORTANT: The DC power supply should be utilised on vehicles with the proper
power output rating.
IMPORTANT: The vehicle should be running while utilising the DC adapter to
EN
power the Zen-O Portable Oxygen Concentrator.
To maximise battery life and run time, avoid letting the battery deplete and use
while connected to a power source whenever possible. The battery will automati-
cally charge whenever the concentrator is connected to a power source. You can
use the device while the battery is charging. The LCD display will indicate whether
the device is operating on battery or external AC power.
The fully charged battery will retain some level of charge for up to thirty days in
this device when not in use - see Caution below for battery removal/storage rec-
ommendation.
IMPORTANT: Battery damage may result if the concentrator's battery is allowed
to discharge completely.
IMPORTANT: After 300 charge/discharge cycles, the battery capacity will be at
least 80% of its original capacity. Replace the battery when the reduced battery
life is affecting your mobility.
CAUTION: Remove battery if this device is not going to be used for more than
seven days. Store battery in a cool, dry place.
CAUTION: Check that this device operates on battery after disconnecting from
the power source.
IMPORTANT: When not using the battery inside the unit, be sure to store it in the
protective sleeve that was provided with the original package.
6 .3 . NASAL CANNULA
Only use a nasal cannula with the following specifications:
• Length: 1.2m (4ft), 2.1m(7ft), 7.6m(25ft) or 15.2m (50ft)
• High flow
• Crush resistant
• Large internal diameter bore
• Suitable for up to 15 litres per minute (lpm) at a max. pressure of 3.6 psi
• Meets substance compatibility of IEC/EN 60601-1
14/338