Install Allen® Ultra Comfort™
Covers on to the supports. Make sure
that—
•
The foam side of the cover is on
the outside.
•
The covers are pulled over the
blue section of the support only. The
black section should not be covered.
NOTE:
Allen® Support Pads are designed to work
with Allen® Ultra Comfort™ Covers only.
To remove a support from the Allen
Advance Table, slide the blue clamp to
the unlocked position. When unlocked,
only the red area will show on the pin.
Chest Support
Put the chest support in position on the Rail
Top at a location dependent on the patient's
gender:
•
Female—install the support so that it
will be above the breasts and below the
clavicle paying close attention to avoid
the brachial plexus.
•
Male—install the pad so that it will be
across the nipple area.
NOTE:
When the support is installed, the indent
should be toward the foot end of the Allen
Advance Table.
Attach the Velcro® straps to hold the support in position.
Install Allen® Ultra Comfort™ Cover on to the support. Make sure
that—
•
The foam side of the cover is on the outside.
•
The cover completely covers the blue material of the support.
Allen® Advance Table User Manual (D-720761 Ver D)
Instructions for Use
29