Adjust The Length Of The Allen Advance Table; Install A Patient Support Top - Hillrom Allen A-71101 Manual Del Usuario

Press and hold the lock control until the Locked
indicator on the display is green.
Try to move the Allen Advance Table to make sure the brakes are
locked. If the brakes did not lock, repeat Step 0 and Step 0.
ADJUST THE LENGTH OF THE ALLEN
ADVANCE TABLE
If there is a support top on the Allen Advance Table, remove the top
(see page 27).
Unlock the brakes.
Lift the cross-tube handle to unlock the cross
tube.
With a person at each end of the Allen
Advance Table, adjust the length as
necessary:
•
Retract—push the columns toward each other.
•
Extend—pull the columns away from each other.
When the cross tube is fully extended, lower
the handle to lock the cross tube into
position.
NOTE:
To lock the cross tube, it must be fully
extended.

INSTALL A PATIENT SUPPORT TOP

WARNING:
Do not use support tops that are not from Allen Medical with
the Allen Advance Table, including Mizuhosi® tops, rail top
or orthopaedic tops. Otherwise, patient fall, injury, or
equipment damage could occur.
WARNING:
Use patient support tops that are designed for the
simultaneous use of tilt and Trendelenburg or Reverse
Trendelenburg only. Otherwise, patient fall, injury, or
equipment damage could occur.
Allen® Advance Table User Manual (D-720761 Ver D)
Instructions for Use
23