Rotate The Support Top 180 - Hillrom Allen A-71101 Manual Del Usuario

ROTATE THE SUPPORT TOP 180°
WARNING:
Before you adjust the Allen Advance Table or use the flip or
tilt features, make sure that the brakes are locked, the
patient is secured against the prone support set, the patient
is fully prepared for the adjustment; the Allen Advance
Table is free of objects that could interfere with the
adjustment, and all loose or unsupported objects have been
secured. Otherwise, patient fall, injury, or equipment
damage could occur.
Make sure that—
•
The brakes are locked (the locked indicator on the
Allen Advance Table display is green).
•
The patient is fully prepared for the adjustment.
•
The Allen Advance Table is in the correct position
for you to install a second support top:
–
The columns are at the same height.
–
The Allen Advance Table and the installed support top are
level (see "LEVEL THE ALLEN ADVANCE TABLE AND
THE SUPPORT TOP" on page 34).
–
The Allen Advance Table is free of objects that could interfere
with adjustment.
–
All loose or unsupported objects have been secured.
•
The rail top has the prone supports installed. (if applicable). If it
does not, install them (see page 27).
Install the second support top as follows:
a. At one end of the Allen Advance
Table, put the upper H-bracket in
position on the bowtie. Hold the
H-bracket so that the open end is
down, the J ends are towards
you, and the bracket is angled
towards you.
b. Install the J ends of the H-bracket
on the bowtie so that the H-
bracket fits into the notches on the
sides of the bowtie.
Allen® Advance Table User Manual (D-720761 Ver D)
Instructions for Use
35