Siemens SINAMICS DCM Manual página 892

Interconnection of STW BOP (r0019)
Signal Meaning
1 = ON
STW BOP.0
0 = OFF (OFF1)
1 = No coast down
STW BOP.1
0 = Coast down (OFF2)
1 = No quick stop
STW BOP.2
0 = Quick stop (OFF3)
STW BOP.3 Reserved
STW BOP.4 Reserved
STW BOP.5 Reserved
STW BOP.6 Reserved
STW BOP.7 = Acknowledge fault
STW BOP.8 Reserved
STW BOP.9 Reserved
STW BOP.10 Reserved
STW BOP.11 Reserved
STW BOP.12 Reserved
STW BOP.13 1 = Motorized potentiometer, raise
STW BOP.14 1 = Motorized potentiometer, lower
STW BOP.15 Reserved
<1> The BICO interconnection represents an example that can be be changed by the user.
<2> Only for CU_DC (SINAMICS DCM).
1 2
DO: CU_DC, CU_DCP
Basic Operator Panel 20 (BOP20) - Control word interconnection
<1>
Interconnection
parameter
p0840[0] = r0019.0
p0844[0] = r0019.1
p0848[0] = r0019.2
p2102[0] = r0019.7
<2> p1035[0] = r0019.13
p1036[0] = r0019.14
<2>
3 4
-
-
-
-
-
-
-
-
-
-
5 6
fp_9912_70_eng.vsd
20.08.18 V01.05.00
PROFIdrive sampling time
7 8
Function diagram
- 9912 -
SINAMICS DCM/DCP