Publicidad
Idiomas disponibles
Idiomas disponibles
EN
d3
30
d4
0
d5
30
d7
2
d15
0
d16
0
PAR.
DEFAULT
A1
10
A2
1
A4
10
A5
1
A7
15
If the evaporator probe is not present (P4=0), it sets the
defrost duration
0
99
min
If the evaporator probe is present (P4=1), it sets the maximum
defrost duration. See also parameter d2
0 = defrost is never activated
Enable defrost at the start of blast chilling and of blast freezing
0
1
- - - -
0 = no
1 = yes
Defrost delay from the beginning of conservation
0
99
min
0 = defrost starts as soon as conservation is started and is
Drip time after a defrost, in which the compressor and the
0
15
min
evaporator fan are switched off and the defrost output is
deactivated
Minimum consecutive compressor-on duration for starting hot
0
99
min
gas defrost, if d1 is set to 1
Pre-drip time if d1 is set to 1 (hot gas defrost), in which the
0
99
min
compressor and the evaporator fan are off and the defrost
output remains activated
MIN.
MAX.
U.M.
TEMPERATURE ALARMS
Cabinet temperature below which the minimum temperature
alarm is activated (relative to the working setpoint, i.e. "r10–
A1" during conservation after blast chilling and "r11–A1" during
0
99
ºC
conservation
code);
see also parameter A11
Enable minimum temperature alarm ("LOW TEMPERATURE"
code):
0
1
- - - -
0 = no
1 = yes
Cabinet temperature above which the maximum temperature
alarm is activated (relative to the working setpoint, i.e.
"r10+A4" during conservation after blast chilling and "r11+A4"
0
99
ºC
during
TEMPERATURE" code);
see also parameter A11 (4)
Enable maximum temperature alarm ("HIGH TEMPERATURE"
code):
0
1
- - - -
0 = no
1 = yes
Temperature alarm delay ("HIGH TEMPERATURE" code and
0
240
min
"LOW TEMPERATURE" code)
repeated in accordance with parameter d0
after
blast
freezing
conservation
after
25
("LOW
TEMPERATURE"
blast
freezing
("HIGH
Publicidad
