Publicidad
Idiomas disponibles
Idiomas disponibles
5
FIRST-TIME USE
N.B.
EVlink Wi-Fi uses an encrypted connection with
-
TLS technology and occupies the TCP 8883 port.
Make sure this firewall port (both the port of the
user's local network and the one managed by the
Internet service provider) is open for outgoing
communications (contact the IT manager)
Ensure
the
user
-
(PC/laptop,
tablet,
iOS operating system, files can only be uploaded
browser installed and that the device is able to
and downloaded if the user has an iCloud account
upload and download files. If the device has an
5.1
First-time use of EVlink Wi-Fi
and if access to this service has previously been
made with the device
1.
Power up the controller and make sure the bLE parameter (enable
EVlink) is set to 1; see the controller instructions.
Ensure the Wi-Fi on the device is on
-
2.
Disconnect the controller.
3.
Carry out the installation of EVlink Wi-Fi as shown in the section
MEASUREMENTS AND INSTALLATION.
4.
Connect EVlink Wi-Fi as shown in the section ELECTRICAL
CONNECTION.
5.
Power up the controller and connect the independent EVlink Wi-Fi
power supply, if used, to the power source.
EVlink Wi-Fi will go into temporary set-up mode. During this mode:
-
EVlink Wi-Fi acts as both an access point (identifying a Wi-Fi
network
called
characters, for example Epoca279A8E) and a data logger
for the connected controller
-
there is no connection with the cloud server.
After 120 s (240 for the first-time use) in set-up mode, EVlink Wi-Fi
will automatically go into run mode if the control panel has not been
accessed (point 9 of this paragraph). During this mode:
-
EVlink Wi-Fi acts as a data logger for the connected
controller
-
there is no connection with the cloud server.
6.
Scan the Wi-Fi networks using the multimedia device and identify a
network called Epoca followed by 6 alphanumeric characters.
If the scan detects more than one network called Epoca, make sure
only one EVlink Wi-Fi is being powered.
7.
Connect to the Epoca network.
has
a
multimedia
device
smartphone)
with
a
web
Epoca
followed
by
6
alphanumeric
In the Security key field enter the password found on the label of
the EVlink Wi-Fi (typically epocawifi).
8.
Open the web browser on the multimedia device.
Enter the address found on the label of the EVlink Wi-Fi (typically
192.168.4.1) in the address bar.
page 21
of 43
EN
Publicidad
