Lumie task Manual Del Usuario página 2

 ENG Safety
Safety
Read instructions for use.
If the unit is damaged, please contact Lumie before use.
Keep away from water and damp.
For indoor use only.
The unit gets warm when the light is on, so make sure that it is not
covered.
Use only the mains power adaptor supplied.
Keep the mains power adaptor and cable away from heated surfaces. If
either are damaged, they should be replaced with an approved Lumie
product.
This appliance does not have a ON/OFF switch. To power down or
reset, remove the mains power adaptor from the wall socket. You should
therefore ensure the socket is easily accessible.
Only to be used by adults and children over 7 years old. Children using the
light, or playing near it, should be supervised.
Caution – do not attempt to service or modify any part of the unit.
If the unit has been stored outside the recommended operating
temperature range (5 °C to 35 °C), allow it to stand for at least 1 hour
before applying power to avoid condensation or overheating.
The light source contained in this luminaire shall only be replaced by
Lumie or an authorised Lumie distributor.
Electromagnetic compatibility
Electrostatic discharge may affect the working of this product. If this
occurs, simply switch off for at least 10 seconds and the unit will reset.
Task uses a touch sensor to control the light. In rare situations, external
conditions may trigger the touch sensor. This can occasionally cause the
light to vary in intensity or turn on or off. If this happens, use the touch
interface to set the light to the previous level. Task will continue to operate
normally and remains safe to use.
Disposal
Do not throw out the mains power adaptor or the unit with normal
domestic waste. Take them to an official recycling point to be disposed
of responsibly.