Before going through the check list below, first refer back to the connections and operating procedures.
Should any problem persist after you have made these checks, consult your nearest Sony service facility.
Symptom
Cause
Remedy
The disc tray does not close.
The disc is not placed correctly.
Place the disc correctly on the disc tray.
Play does not start.
Dirty disc.
Clean the disc.
The disc is inserted upside down.
Insert the disc with the printed side up.
tl is engaged.
Press B or IB again to release it.
Moisture condensation.
Leave the unit turned on for approximately
one hour.
Sound is not heard.
Loose connection.
Insert the plug firmly.
Connection is incorrect.
;
Check the connection referring to "Hooking
Up the System".
The LINE OUT/PHONE LEVEL control (or
Turn the control clockwise, or press LINE
LINE OUT LEVEL +/— on the remote
OUT LEVEL + on the remote commander.
commander) is set to the minimum.
The BALANCED OUT jacks are used for
Set the BALANCED OUT switch to ON.
connections, but the BALANCED OUT
switch is set to OFF.
Play does not begin from the first selection.
The unit is in the program, shuffle, or
Press CONTINUE.
custom index mode.
Level of the recorded sound has not been
When the VARIABLE LINE OUT jacks are
Do not turn the LINE OUT /PHONE LEVEL
fixed even though the recording level was
used, the LINE OUT/PHONE LEVEL
control (or press LINE OUT LEVEL +/-)
preset on the tape deck.
control (or LINE OUT LEVEL +/— on the
while recording.
remote commander) is turned (or pressed)
while recording.
'
The remote commander does not operate
The batteries are run down.
Replace both batteries.
the unit.
The remote commander is not pointed at
Point the remote commander at the sensor.
the remote sensor.
There is an obstacle between the remote
Remove the obstacle.
commander and the unit.
The remote commander is too far from the
Move closer.
unit.
76