Bodum BISTRO Instrucciones De Uso página 14

PROGRAMMING
YOUR OWN
SETTINGS
NOTE: After you have cancelled the baking process by pressing
the START/STOP button at least 3 seconds, all previously entered
settings will be lost. In this case, you must start the baking process
again (see: "Tips for Best Results"). Thus, for short interruptions (e.g.
for adding further ingredients or pushing down the ingredients back
to the kneading paddle) it is best to unplug the appliance or touch
the START/STOP button only shortly for pausing operation for 3 min-
utes at the maximum. However, please keep in mind that the appli-
ance will re-assume operation automatically after 3 minutes.
NOTE: If the program has not entered the rising phase at the
moment the power supply cuts off for more than 10 minutes, you
can start the program again, without filling in new ingredients. This
way, in total, the dough will be kneaded for a somewhat longer time
duration.
The program Homemade (14) is reserved for your own baking
program. For each program phase, you can enter the desired time
duration. To disable a program phase, simply enter the time dura-
tion 0:00. This way, you can put your own special baking ideas into
practice. The program phases and default time durations are given
above (see: "Program Phases").
NOTE: Your settings will be deleted from memory, after disconnect-
ing the appliance from power supply for more than 10 minutes.
Thereafter, the defaults given in the table above will be active again.
1. Touch the SETTING button to call the Homemade program. The
program number 14 and the currently programmed total process-
ing time will be shown on the LCD screen.
2. Again touch the SETTING button to switch to the first program
phase. The icon and number of the program phase will be shown
with the pre-set time duration flashing.
3. Use the +TIME and -TIME buttons to set the desired time duration.
4. With the desired time duration flashing on the LCD screen, touch
the SETTING button again to switch to the next program phase.
5. Repeat steps 3 and 4 until you have programmed all program
phases beginning with the first kneading phase up to the maxi-
mum keep warm time duration.
TIP: When touching the START/STOP button during programming,
the appliance will finish programming, showing the complete time
duration of your program.
6. After programming, you can start your Homemade program by
touching the START/STOP button.
TIP: As with most other programs of the Bread Maker, you can start
your Homemade program belatedly. After completing programming,
simply touch the +TIME or -TIME buttons to apply the desired time
delay. The icon of pre-set time will flash on the LCD screen to indi-
cate that the time delay function is active and the time duration until
finishing the baking process is shown. See below: "Using the Timer".
14