Bodum BISTRO Instrucciones De Uso página 8

hard to remove, fill the bread pan with hot dishwater for approx.
30 minutes. Then try again. If required, use the provided hook to
lift the kneading paddle out of the bread pan.
7. Clean all surfaces of the bread pan and the kneading paddle using
warm dishwater and a soft brush or cloth. Especially the drive
shaft protruding from the bottom of the bread pan interior needs
thorough cleaning. It must be smooth and shiny. Otherwise, the
kneading paddle could stick to the drive shaft after next operation.
TIP: Ensure that the opening in the kneading paddle is completely
clean and smooth. Residues within the opening would stick to the
drive shaft, thus making it quite difficult to remove the kneading
paddle from the drive shaft after operation.
8. After cleaning, hold the kneading paddle and bread pan up to
the light to check, whether the opening in the kneading paddle
and the drive shaft are clean. If there are any residues, you
should soak kneading paddle and bread pan for some minutes
in hot dishwater. Thereafter clean thoroughly, using a soft cloth.
9. Dry all parts thoroughly. Thereafter leave the appliance (with the
lid open) and the parts dry naturally for ½ hour, where they are
out of reach of young children.
TIP: It is good advice to reassemble the appliance after cleaning.
This way, you protect the parts from damage, loss, and dust.
IMPORTANT: Before reassembling the appliance, always ensure
that the parts of the appliance are clean and completely dry. This
is crucial especially for the heating compartment and exterior of
the bread pan. Otherwise, moisture could get onto the heating ele-
ments and cause risk of overheating and electric shock.
10. Push the kneading paddle onto the drive shaft in the bread pan.
11. Turn the bread pan within the heating compartment until it set-
tles down on the coupling of the kneading works. Then turn the
bread pan clockwise to lock it onto the coupling.
TIP: If you cannot push the bread pan down completely, turn the
drive shaft/kneading paddle a little, then try again.
12. Close the lid.
Preheating of the device is not required. (If preheating the device
before temperature or abnormal testing is waived).
8