Moretti Forni T Serie Manual Instrucciones página 66

save programs. Once the DEFAULT procedure is run, re-enter the
saved programs with the "IMPORT USB" procedure described in
3.6.7
To start the process, press MENU, select HELP and press "OK" to
enter the FACTORY DEFAULT, and confirm. Press "OK" to confirm
or "RETURN "to cancel the operation displayed on the screen.
The configuration screens will be displayed if you press ok. Use the
up/down arrow keys to select the desired setting and press "OK" to
confirm. At the end of the requested data you will be redirected to the
initial screen.
RESET at this point as described in 5.18.
NOTE:
To display the current oven configuration, see INFO
tab and for parameters relating to gas settings see GAS
PARAMETERS, both found under the CUSTOMER CARE menu.
WARNING!
THE EQUIPMENT SOFTWARE IS
PROVIDED WITH SETTINGS FOR METHANE G20 AND GPL
G30-G31 BY DEFAULT; IF A FACTORY DEFAULT IS
PERFORMED DURING THE OVEN'S LFE CYCLE, THE
INTERNAL PARAMETERS MUST BECONTROLLED AND
RESET FOR THE TYPE OF GAS SUPPLYAS PER TAB.1 PER
COUNTRY OF INSTALLATION (section 3.4.4).
5.20 DISMANTLING
When dismantling the appliance or spare parts, it is necessary to separate
the various components per type of material and then provide for
disposal in accordance with the laws and regulations in force.
UK/21