Environmental Protection (Advice On Using The Machine In Ways That Respect The Environment); O P T I O N A L Acc E S S O R I E S O Nrequest; Accessories Available For Particular Types Of Work) - EMAK TN 4500 Manual De Uso Y Mantenimiento

- Make sure all parts removed during
maintenance are refitted.
Check
1. Whenever the machine is used make sure
there are no oil leaks.
2. With the load box fully lowered check the oil
level using the filler cap with dipstick
(B, Fig.18).
Gearbox
1. Draw off the old oil using a syringe.
2. Pour in new oil through the filler neck (B)
until the oil level reaches half way between
the maximum level notch and the end of the
dipstick (minimum level).
Crawler tracks
Periodically clean mud from the adjuster nut
(A, Fig.28) and locking screw (B) top avoid
excessive stiffening. Lubricate the track
tensioner after each use.
Power take-off (PTO)
At each use check that the seal is perfectly oil-
tight.
Grease application
The following par ts need to be greased
regularly:
1. The box supports (Fig. 25).
2. The 4 crawler rollers (Fig. 26).
CAUTION:
- Apply grease also on sliding and rough not
mentioned.
- Apply grease regularly using a grease gun.
Major servicing
It is advisable to have the machine inspected by
a specialist technician at an Authorised Service
Centre at the end of each season, if used
intensively, or every two years in the case of
normal use.
8. ENVIRONMENTAL PROTECTION
Environmental protection should be a priority
of considerable importance when using the
machine, for the benefit of both social cohesion
and the environment in which we live.
- Try not to cause any disturbance to the
surrounding area.
- Always adhere strictly to local bylaws for
disposal of the transported material.
- Scrupulously comply with local regulations
and provisions for the disposal of oils, petrol,
batteries, filters, deteriorated parts or any
elements which have a strong impact on the
environment. This waste must not be
disposed of as normal waste, it must be
separated and taken to specified waste
disposal centres where the material will be
recycled.
Demolition and disposal
When the machine reaches the end of its
service life, do not dispose of it into the
environment; instead take it to a waste disposal
centre.
Most materials used in the manufacture of the
machine are recyclable; all metals (steel,
aluminium, brass) can be delivered to a normal
recycling station. For information contact your
local waste recycling service. Waste disposal
must be carried out with respect for the
environment, avoiding soil, air and water
pollution.
In all cases, applicable local legislation must
be complied with.
When the machine is scrapped also the CE mark
label must be destroyed together with this
manual.
9. OPTIONAL ACCESSORIES ON
REQUEST
Sideboards raising kit (Fig. 27)
Conversion Kit to increase the height of the box
sideboards, facilitating the transport of bulky
loads.
WARNING: Do not alter or extend the
load bed to increase the capacity of the
machine: the use of higher side boards
cannot be construed as authorization to
exceed the machine's load limits.
I
GB
F
D
E
NL
P
H
SK
CZ
RUS
UK
PL
FIN
BIH
SRB
HR
37