Parameter's Index - Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador

12

Parameter's index

FACTORY
PARAM.
VALUE
Selecting automation system model
see chap. 13
Automatic closure after pause time (from gate completely open)
Automatic gate closing after mains power outage
Selecting step mode control function (PP)
Pre- ashing
Condominium function for partial open command (PED)
Enabling operator present function.
Gate open indicator / photocell test function and "battery saving"
Setting deceleration during opening (and closing for BG30/1600 - BG30/2200)
Setting deceleration during closing (High Speed and Reversible Motors only)
Setting gate open limit switch constant speed approach distance
Setting gate closed limit switch constant speed approach distance
Partial opening adjustment (%)
COR output operating mode
Setting automatic closing time
Enabling of management for opening with automatic re-closure exclusion.
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention).
Setting motor torque
Setting obstacle impact force sensitivity
Setting start acceleration during opening (and closing for BG30/1600 - BG30/2200)
Setting start acceleration during closing (High Speed and Reversible Motors only)
Enabling maximum torque boost at start of manoeuvre
Setting motor torque during position recovery
Setting opening speed (and closing for BG30/1600 - BG30/2200)
Setting closing speed (High Speed and Reversible Motors only)
Setting end of manoeuvre constant approach speed
Setting number of automatic closure attempts after activation of sensing
edge or obstacle detection (crush protection)
Setting photocell mode during gate opening (FT1)
Setting photocell mode during gate closing (FT1)
Photocell (FT1) mode with gate closed
Setting photocell mode during gate opening (FT2)
Setting photocell mode during gate closing (FT2)
Photocell (FT2) mode with gate closed
Enable close command 6 s after activation of photocell (FT1-FT2)
Setting motor stop distance
Selecting installation position of motor relative to gate (seen from interior
side)
Con guring sensing edge COS1
Con guring sensing edge COS2
Con guring radio channel 1 (PR1)
66
DESCRIPTION PAGE
68
68
68
68
68
69
69
69
69
69
69
69
69
69
69
70
70
70
70
70
70
70
71
71
71
71
71
71
71
71
71
72
72
72
72
72
72
72
73