Reset Procedure - SICK C2000 Manual Del Usuario

Operating Instructions
C 2000
M 2000
8008684/YJC8/2015-03-30
8 008 684/RI57/2007-11-28
Product Description
sender
Display element Meaning/function
The C 2000, M 2000 and M 2000-A/P units have the following
LED yellow Power on
display elements:
7-segment display Display of fault codes and codes for commissioning
Sender
Table 3-2: Display elements of the sender
Display element Meaning/function
Receiver
LED green Light path free
LED red Light path broken
LED amber Dirt contamination
LED yellow Control switch prompt
7-segment display Display of fault codes and codes for commissioning
Table 3-3: Display elements of the receiver
The 7-segment display shows the configured address and sender
power (M 2000 only) for a few seconds after the device is switched
on. The commissioning codes are explained in Section 6.2 Alignment
of light beams and the error codes in Section 8 Troubleshooting.
3.4

Reset procedure

To reverse inadvertent changes, the devices can be reset to the
default state by means of the following procedure:
Fig. 3-10: Resetting to default state,
a = 7-segment display
© SICK AG • Safety Systems • Germany • All rights reserved
s = Signal change GND z nc
Chapter 3
2 5 5