Tests On The C 2000/M 2000 - SICK C2000 Manual Del Usuario

Chapter 6
8008684/YJC8/2015-03-30
2 7 2
8 008 684/RI57/2007-11-28
Commissioning
3. Observe the alignment information on the seven-segment display of
the receiver or the receiver/sender module (M 2000-A/P) to adjust
the photoelectric switch. Resecure the clamping screws when
optimum alignment is attained.
Key to displays:
0 The receiver is unable to synchronise with the sender, the
alignment is very imprecise.
1 Some light beams are not yet hitting the receiver.
2 All light beams are hitting the receiver, but the alignment is
still not yet optimum.
No The alignment is now at its optimum, look the device
display at this position.
If the optimum alignment is held for more than 2 minutes with no
further intervention, the system switches out of alignment mode. To
resume the alignment process, the power must be cut and then
reconnected.
6.3 Tests on the C 2000 / M 2000
The following points must be observed in order to ensure regulation
use of the devices:
The units must be installed and connected only by qualified
personnel – that is to say, personnel trained and experienced in
operation of the power-driven machinery being checked, and
familiar with the relevant statutory workplace safety and accident
prevention regulations, standards and generally accepted technical
rules (e.g. DIN standards, VDE rules, technical rules and regulations
of other EU states) such that they are able to assess the opera-
tional safety of the machinery concerned. Such personnel are
usually qualified employees of the manufacturers of non-contact
protective devices, or personnel who have undergone training by
the manufacturers of such devices or who are primarily engaged in
testing of non-contact protective devices and have been commis-
sioned to carry out the work by the company operating the devices.
1. Pre-commissioning test of the machine protective device by qualified
personnel:
Multibeam Photoelectric Safety Switch M 2000
© SICK AG • Safety Systems • Germany • All rights reserved
Operating Instructions
Safety Light Curtain C 2000