Configuration Of The Sender Range (M 2000 Only) - SICK C2000 Manual Del Usuario

Chapter 5
Note
DANGER
Note
8008684/YJC8/2015-03-30
2 6 8
8 008 684/RI57/2007-11-28
Electrical Installation
SEL 1
nc
0 V
nc
0 V
Table 5-1: Selection of beam coding with SEL 1 and SEL 2.
nc = not connected
The sender and receiver must have the same address. The code ad-
dresses are subject to the combinations set out in Table 5-1.
On the M 2000-A/P code 1 is set as the factory default. No additional
beam coding is possible.
Insulate non-connected wire ends!
The non-connected wire ends must be insulated to ensure safe coding.
5.7 Configuration of the sender range
(M 2000 only)
To keep any possible interference with adjacent photoelectric switches
to a minimum, a long range should only be set where essential.
Fig. 5-10: Configuration of the sender range, 0 V = Range 0 ... 6 m
S = Sender
The HRANGE connection on the sender can be used to choose
between two sender ranges. The following assignment applies:
Multibeam Photoelectric Safety Switch M 2000
SEL 2
nc
nc
0 V
0 V
R = Receiver
© SICK AG • Safety Systems • Germany • All rights reserved
Operating Instructions
Safety Light Curtain C 2000
Code
1
2
3
not allowed (except
for reset procedure)
a = Machine controller