Configuration Of The Cyclic System Test; Configuration Of The Beam Coding - SICK C2000 Manual Del Usuario

Operating Instructions
C 2000
M 2000
E x p l a n a t i o n
Note
E x p l a n a t i o n
8008684/YJC8/2015-03-30
8 008 684/RI57/2007-11-28
Electrical Installation
5.5

Configuration of the cyclic system test

Fig. 5-8: Configuration of the cyclic system test, connection of the test input and the
OSSD outputs
S = Sender
R = Receiver
If the cyclic system test (external test) is configured, only OSSD 1 need
be wired. Section 3.2.3 describes the cyclic system test.
For the cyclic system test follow the test connections to IEC 61496-1
(A2).
5.6

Configuration of the beam coding

Fig. 5-9: Example circuit: Connection of the beam coding inputs, address 3
S = Sender
nc = not connected
The light beams are coded by connecting the input SEL 2 to 0 V.
© SICK AG • Safety Systems • Germany • All rights reserved
a = Machine
s = Test generation and evaluation
R = Receiver
Chapter 5
a = Machine
2 6 7