Pulse Oximeter - Philips Patient Telemonitoring Set Instrucciones De Uso

Pulse
The Pulse Oximeter is a plastic display case with a finger-clip sensor
Oximeter
attached to it. The front of the case has the following elements, as shown
in the figure below. The rear of the case has a compartment for batteries
that power the device.
Pulse
An LED display window shows the blood oxygen level (%SpO
Oximeter
pulse rate (in beats per minute) measured from the end of your finger.
Display Case LEDs below the display window light to indicate which measurement is
being displayed -- %SpO
Pushing the START button causes the Pulse Oximeter to begin taking a
measurement.
The Radio Test button
measurements from the Pulse Oximeter to the Home Hub or TeleStation.
The Finger-clip sensor is used to measure your blood oxygen level
and pulse rate. The sensor is clipped on the end of one of your fingers.
The Finger-clip contains an LED light source that shines light on your
finger. Light transmitted through the blood in your finger is received by a
photo sensitive element and electronics in the display case uses the
transmitted light to determine your blood oxygen level and pulse rate.
Display
Finger-clip
sensor
or pulse (/min.).
2
T
is used to test the transmission of
Radio Test
button
Philips Telemonitoring Set
Device Descriptions
) and
2
START
button
2-11