Philips Patient Telemonitoring Set Instrucciones De Uso página 47

The procedure for measuring your blood pressure with the M3815A
Blood Pressure Monitor is as follows:
Step 1.
Step 2.
Step 3.
Step 4.
Warning Do not allow the air hose to kink or twist.
Step 5.
Note The cuff should be snug but not too tight. Leave room for two fingers to
fit under the cuff.
Step 6.
Step 7.
Step 8.
Sit comfortably with your forearm resting on a flat surface and
your legs uncrossed. The center of your upper arm should be at
about the same height as your heart.
Put your hand through the
cuff and slide the cuff up your
forearm.
Move the cuff so it is on your upper
arm and the bottom of the cuff is about
1 inch above your elbow
Position the air hose so it dangles
on the inside of your arm.
Pull on the end of the cuff to tighten it.
Then fold the cuff end back over the metal D-ring.
Fasten the end of the cuff to the Velcro
Make sure that your hand is open and relaxed with the palm up.
Press the START/STOP button. The cuff will inflate and feel
tight.
Sit still and do not move your arm during the measurement.
Device Usage
®
closure.
Philips Telemonitoring Set
2-31