Measuring Blood Oxygen And Pulse Rate - Philips Patient Telemonitoring Set Instrucciones De Uso

Device Usage
Measuring The following steps describe how to use the Pulse Oximeter to measure
Blood your blood oxygen level (%SpO
Oxygen and turned off. If you want to turn pulse on, press and hold both the START
Pulse Rate and Test buttons (T in circle) for more than 3 seconds. Repeating this
step will turn pulse off again.
Step 1.
Step 2.
Step 3.
Step 4.
2-40
Philips Telemonitoring Set
Sit within 20 ft. of the Home Hub or TeleStation with your hand
resting on a flat surface and the Pulse Oximeter in front of you.
Open the sensor and fully insert
your finger (index, middle, or ring,
but not your thumb) until the end of
your finger reaches the finger stop.
The cable should extend over your
finger toward your wrist as shown
in the figure.
Sit comfortably with your hand
resting on the surface so that it
can remain still.
Press the START button and hold your hand still during the
measurement.
) and pulse rate. By default, pulse rate is
2
Press Start button
Hold hand still