Radio Test - Philips Patient Telemonitoring Set Instrucciones De Uso

Overview

Radio Test

If the data/holding results light does not come on after you take a
measurement, another step that can be taken is to perform a Radio Test.
The Radio Test makes sure that your measurements are being properly
sent from the measurement device to the Home Hub/TeleStation. The
RADIO TEST button, {
To perform the Radio Test, follow these steps:
Step 1.
Note If the using phone light on the Home Hub/TeleStation lights, stop and
wait until it turns off before performing the Radio Test.
The following messages will appear on the indicated device.
The Home Hub/TeleStation should beep:
If the Home Hub/TeleStation does not beep, do the following:
If the Radio Test is still not successful, refer to the following
Troubleshooting tables to try to further resolve the problem
4-2
Troubleshooting
1. Press and hold down the RADIO TEST button on the
measurement device for 3 to 5 seconds or until the Home Hub/
TeleStation starts beeping.
The Scale and Pulse Oximeter will display rF.
The Rhythm Strip Recorder's RELAX light will flash once per
second.
– Make sure the measurement device has fresh batteries
– see if there are any large objects between the measurement
device and the Home Hub/TeleStation.
If there are large objects, move the measurement device to a
different location.
If there are no large objects, move the measurement device
closer to the Home Hub/TeleStation.
– Make sure there are no cordless or cellular telephones or
computers in use near the Home Hub/TeleStation.
– Repeat the Radio Test
or }, is on the front of the device.
T