Pulse Oximeter - Philips Patient Telemonitoring Set Instrucciones De Uso

Pulse
The following table describes problems that may occur with the Pulse
Oximeter
Oximeter.
Problem Reason
appears on A hardware malfunction is
the display detected.
appears A reading was not obtained.
on the
display
appears Batteries are too low for the
on the Pulse Oximeter to work
display properly.
and flashes.
appears Indicates that the batteries are
on the good.
display
along with a rising
audio tone after
battery replacement
appears There is a hardware
on the malfunction.
display
along with a low
audio tone after
battery replacement.
Troubleshooting Tables
Possible Solutions
If condition persists, contact your healthcare
provider.
- Reduce the light.
- Warm your finger.
- Keep your hand still.
- Repeat the measurement.
- If the condition persists, contact your
healthcare provider.
- Replace all 4 batteries following the
procedure in Chapter 3.
- Perform a Radio Test.
No action required. Proceed with Pulse
Oximeter measurement.
- Replace all 4 batteries following the
procedure in Chapter 3.
- Perform a Radio Test.
- If condition persists, contact your
healthcare provider.
Troubleshooting
4-13