Philips Patient Telemonitoring Set Instrucciones De Uso página 77

Problem Reason
When you take a There may be a conflict
measurement, the between your special phone
data/holding service and the Home Hub/
results light TeleStation connection,
remains on or a problem with your
and you have a telephone line or your
special phone service healthcare provider's
such as voice mail connection.
Troubleshooting Tables
Possible Solutions
- Have someone call and leave a message on
your special telephone service
Perform the CALL button test as follows:
Note: Keep your phone on the hook for
the following steps unless told otherwise.
- Find the CALL button on the far right of
the back panel of the Home Hub/
TeleStation
- Press the CALL button for less than 2
seconds. The Home Hub/TeleStation
should beep.
(For some Home Hubs, you may need to
use a pen or other pointed object to depress
the CALL button)
- Release the CALL button.
- In 10 seconds, the using phone light
should turn on and the Home Hub/
TeleStation will dial your healthcare
provider.
- After a few minutes, the using phone
light and the data/holding results light
should turn off.
- If the data/holding results light is still
on, listen to the saved message and then
delete it.
- Press the CALL button for less than 2
seconds. The Home Hub/TeleStation
should beep once.
- Release the CALL button.
- In 10 seconds, the using phone light
should turn on and the Home Hub/
TeleStation will dial your healthcare
provider.
Troubleshooting
4-5