User Calibration; Calibration Test - Uline OHAUS EXPLORER H-4737 Manual Del Usuario

USER CALIBRATION

Use this calibration method to calibrate the balance using
a defined mass.
1. With no load on the scale, press USER CALIBRATION
from the calibration sub-menu. The display shows
the current full load (span) calibration point and
calibration unit of measure.
2. To change the value to a user-defined weight, touch
ENTER VALUE. Enter the weight via the popup screen.
The balance then prompts for the user-defined
weight.
3. Place the specified calibration weight on the
balance and the calibration process completes.
The display shows status, then returns to the current
application.

CALIBRATION TEST

Use this calibration method to compare a known
calibration weight against the stored span calibration
data.
With no load on the balance, press CAL TEST to begin the
process.
The balance captures the zero point, then prompts for the
span value.
The display shows status, followed by the difference
between the current calibration weight and the stored
calibration data.
After three seconds, the display returns to the current
application.
TURNING AN APPLICATION ON/OFF
1. In the balance Setup Menu enter the Application
Modes sub-menu to activate the desired balance
applications. Only one can be running at a time.
2. Touch the line of the desired application.
3. In the item option screen, touch ENABLED to toggle
it on or off.
PAGE 6 OF 96
OPERATION CONTINUED
4. Once an application is enabled (turned on) it may
5. The current menu item status is shown:
APPLICATIONS
The balance can be configured to operate in various
application modes. Touch APPLICATIONS to choose – or
the top button in the application area.
be chosen from the Applications shortcut (top-left of
all home screens).
OFF = disabled
ON = enabled
NOTE: Before using any application, be sure
the balance has been leveled and calibrated.
The balance is shipped with all units enabled.
0721 IH-4737