Breville VCF152X Instrucciones De Uso página 38

TROUBLESHOOTING GUIDE - GRINDER
Problem
Optimum Grind
Setting is
producing an
under extracted
espresso
No coffee grinds
coming from the
Grinder Outlet
Coffee grinds
are coarse
when on a fine
Grind Setting
Grinder display
shows Hi or Lo
38
VCF152X_VCF153X_21MLM1 (EMEA).indd 38 VCF152X_VCF153X_21MLM1 (EMEA).indd 38
Possible Cause
New Burrs are bedding in.
This is normal for the first
few uses.
Beans are losing freshness.
Not enough coffee grinds
used.
Grinds not tamped
(compacted) enough.
No coffee beans in the
Bean Hopper.
Hopper Gates are closed or
not fully open.
The Grind Chamber or
Outlet is blocked.
Grind Setting not correct.
Top Burr not seated
correctly. Coffee beans or
grinds are caught around &
under the Top Burr.
The grinder is providing
feedback that you are
wanting to use a grind
size that is outside the
recommended average
range for Espresso.
What To Do
Turn the Bean Hopper clockwise
in small increments to a finer Grind
Setting to keep an optimum espresso
extraction. Use the information on
pages 14-15 to help.
Fill with more coffee grinds.
Tamp more firmly. See Espresso
Extraction Guide section, page 15.
Fill the Bean Hopper with freshly
roasted coffee beans.
Turn the Bean Hopper in a clockwise
direction. At Grind Setting 30, Hopper
Gates are fully open. See Removable
Bean Hopper section, page 8.
Grinder needs cleaning. See Care &
Cleaning, pages 29-30.
Adjust the Grind Settings by turning
the Bean Hopper. See Tips for
Grinding, & Extraction, pages 14-15.
Top Burr needs cleaning.
See Care & Cleaning, pages 29-30.
Experiment with optimising your
brewing within the standard
recommended grind size range.
If your preference is for a very fine or
coarse grind, then it is perfectly OK to
use the grinder whilst it is displaying
Hi or Lo.
5/14/21 15:52 5/14/21 15:52