Electrics - Festo 8116512 Instrucciones De Servicio

Adaptive shape gripper

5.3 Electrics

36
•
Mount all the components securely onto the slotted profile plate.
•
Make sure that limit switches are not actuated from the front.
•
Set all components up so that activation of switches and disconnectors is not made
difficult.
•
Adhere to the instructions regarding positioning of the components.
Disconnect from all sources of electrical power!
•
Switch off the power supply before working on the circuit.
•
Please note that electrical energy may be stored in individual components. Further
information on this issue is available in the datasheets and operating instructions
included with the components.
Warning!
Capacitors inside the device may still be charged even after being disconnected from
all sources of voltage.
•
Maximum permissible current loads for connector cables and devices must not be
exceeded.
– Always compare the current ratings of the device, the connector cable
fuse.
– In the event that these are not the same, use a separate upstream fuse in order to
provide appropriate overcurrent protection.
•
Devices with a grounding terminal must always be grounded.
– If a ground connection (green-yellow laboratory socket) is available,
it must always be connected to protective ground. The protective ground
must always be connected first (before voltage), and must always be
disconnected last (after disconnecting the voltage).
•
Some devices have a high leakage current. These devices must be additionally
grounded with a protective grounding conductor.
CAUTION
WARNING
and the
© Festo Didactic 8116523