Festo 8116512 Instrucciones De Servicio página 38

Adaptive shape gripper
38
• Risk of accident due to pneumatic tubing slipping off!
– Use shortest possible tubing connections.
– If pneumatic tubing slips off:
Switch off the compressed air supply immediately.
•
Do not exceed the maximum permissible pressure of 6 bar (600 kPa).
•
Do not switch on the compressed air until all the tubing connections have been
established and secured.
•
Do not disconnect pneumatic tubing while under pressure.
•
Do not attempt to connect pneumatic tubing or push-in connectors with your hands or
fingers.
•
Pneumatic circuit setup:
Connect the devices with plastic tubing with an outside diameter of 4 or 6 mm. Push
the pneumatic tubing into the push-in connector as far as it will go.
•
Switch off the compressed air supply before dismantling the circuit.
•
Dismantling the pneumatic circuit
Press the blue release ring down so that the pneumatic tubing can be pulled out.
•
Noise due to escaping compressed air
– Noise caused by escaping compressed air may damage your hearing.
Reduce noise by using pneumatic mufflers, or wear hearing protection
if noise cannot be avoided.
– All of the exhaust ports of the components included in the equipment sets
are equipped with mufflers. Do not remove these mufflers.
WARNING
CAUTION
© Festo Didactic 8116523