Canon PIXMA MP600R Manual De Instrucciones página 43

3
Confirm that the setup program detects the machine automatically.
MP600R connected to the network is detected automatically.
Note
If the machine has not been detected, make sure of the following and click Update.
– The machine is on.
– The firewall function of any security software is turned off. For details on firewall function, see
"On Firewall Function" on page 21.
– When using wireless LAN, the computer can communicate with the access point.
– When using wired LAN, the machine is connected to the hub.
– The machine is not set to use access control.
If the firewall function is turned on in Windows XP with Service Pack 1, a message asking
whether to turn the firewall function off is displayed during setup. If it is displayed, click Yes to
turn it off. The firewall function is turned back on automatically after setup is complete.
– For information on how to confirm Windows XP Service Pack versions, see "Confirming the
version of Windows XP" on page 74.
– Some programs that switch the network environment depending on your system environment
will enable a firewall function by default. Check the settings on any such software.
4
Select the machine on the Printers dialog
box, and click Next.
5
When the Network Setup of the Card Slot
dialog box is displayed, specify the drive
letter, then click Next.
If "Communication with the Card Slot failed." is
displayed
Click Retry. If it still fails, see ""Communication with
the Card Slot failed" is displayed during setup" on
page 72.
Note
If "Cannot map any more drives, because all the
drive letters are assigned" is displayed, make an
available drive letter manually, and try the network
setup of the Card Slot again.
If "The Card Slot is already mapped as Network
Drive to this computer" is displayed, the Card Slot is
already set up. Click OK, then click Next.
40 Setting Up the Machine and the Computer (Windows)