The Target Access Point Is Not Detected; Cannot Connect To The Target Access Point - Canon PIXMA MP600R Manual De Instrucciones

Problem

The target access point is not detected

Cannot connect to the target access
point
Possible Cause and Measures
If the machine or your computer cannot communicate with the target access
point, follow the procedure below.
(1)Make sure that the access point is on and then click Update on the Access
Points dialog box.
(2)If the access point is still not detected, move your machine closer to the
access point and remove possible obstructions, then click Update.
(3)Make sure that your computer can communicate with the access point.
Note
For details, refer to "Checking if the computer and the machine (access point)
can communicate with each other" in the Network Guide on-screen manual.
(4)Unplug the access point from the wall outlet and plug it in, then click Update.
Using your access point's utility software, check if your access point is set to
the stealth mode, i.e., set not to broadcast its SSID, or is set to reject clients
whose SSID is set to ANY. If so, click Manual Setup and enter the access
point's SSID in SSID. For details, see "The Access Points dialog box is
displayed during setup" on page 67.
The wireless channel to be used may be limited depending on wireless
network devices installed on the computer. Confirm the wireless channels
available for the network device. For details, refer to the instruction manual of
your computer or your wireless network device.
Make sure that the channel set to the access point is valid to communicate
with the computer, confirmed above. If not, change the channel set to the
access point.
Some access points are capable of switching automatically between wireless
channels. This machine may not be able to connect an access point if its
channel is set to automatic or the equivalent, or to a channel outside of the
range 1 to 13. Configure the access point to use any channel between 1 and
13.
Make sure that there is no barrier or obstacle between the access point and
the machine.
Confirm the network name/SSID of the target access point and set the
machine to use the identical network name/SSID. If the network name/SSID
is different in the machine and the access point, the machine cannot connect
to the access point. For details, see "The Access Points dialog box is
displayed during setup" on page 67.
Note
This machine does not support WPA-Enterprise or WPA2-Enterprise. When you
select an access point set to use WPA-Enterprise or WPA2-Enterprise, it is
grayed out and cannot be set up.
Make sure that the machine and the access point can communicate with
each other under this setting. When encryption is set to the access point, set
up the encryption of the machine to match the settings on the access point. If
the WEP/WPA/WPA2 (encryption key) is different in the machine and the
access point, the machine cannot communicate with the access point. For
details, see "How to set a WEP/WPA/WPA2 key" on page 65.
Troubleshooting 63