Setting Up - Canon PIXMA MP600R Manual De Instrucciones

Setting Up

Setting up for use over wireless LAN
This section describes how to set up the machine to be used over wireless LAN (infrastructure
mode).
Important
Follow this procedure only when the machine has not yet been set up to be connected to a
wireless LAN. If the machine has already been connected to a wireless LAN, see "Setting up an
additional LAN-connected computer" on page 58.
1
Confirm that the screen shown on the right
appears.
Important
This step should follow from step 9 in "Installing the
Software" on page 42. If the Setup Preparations
screen has not displayed yet, go back to the procedure
in "Installing the Software" on page 42 to complete the
installation of the software.
2
Connect the machine with a USB cable.
Note
To set up the machine that is not yet connected to a
LAN, connect to it with a USB cable.
46 Setting Up the Machine and the Computer (Macintosh)