Step
ground.
Does the ohmmeter indicate the specified value?
Repair the open ground circuit for the rear window wiper motor.
8
Is the repair complete?
1. Turn the ignition ON.
1. Turn the ignition ON.
2. Turn the rear window wiper ON.
2. Turn the rear window wiper ON.
3. Check the voltage at the BRN/WHT wire at the
3. Check the voltage at the BRN/WHT wire at the
9
rear window wiper connector.
Does the voltmeter indicate the specified value?
10 Replace the rear window wiper motor.
Is the repair complete?
1. Disconnect the rear window wiper switch
1. Disconnect the rear window wiper switch
electrical connector.
2. Turn the ignition ON.
2. Turn the ignition ON.
11
3. Check the voltage at connector terminal A3.
3. Check the voltage at connector terminal A3.
Is the voltage equal to the specified value?
Repair the open circuit between fuse F12 and the rear window
12
wiper switch connector terminal A3. Is the repair complete?
1. Connect an ohmmeter between terminals A1 and
1. Connect an ohmmeter between terminals A1 and
A3 of the rear window wiper switch.
2. Move the rear window wiper switch to the WIPE
2. Move the rear window wiper switch to the WIPE
13
position.
3. Does the ohmmeter indicate the specified value?
3. Does the ohmmeter indicate the specified value?
Repair the open circuit between terminal A1 of the rear window wiper
connector and the rear window wiper motor.
14
Is the repair complete?
15 Replace the rear window wiper switch.
Is the repair complete?
Step
1 Check the washer fluid level.
Is there fluid in the washer reservoir?
2 Fill the washer reservoir.
Is the repair complete?
3 Verify that the hoses are not obstructed or leaking.
Action
REAR WINDOW WASHER SYSTEM
Action
Value(s)
Yes
-
System OK
11 - 14 v
Go to Step 10 Go to Step 11
Go to Step 10 Go to Step 11
Go to Step 10 Go to Step 11
Go to Step 10 Go to Step 11
-
System OK
11 - 14 v
Go to Step 13 Go to Step 12
Go to Step 13 Go to Step 12
Go to Step 13 Go to Step 12
Go to Step 13 Go to Step 12
-
System OK
≈ 0 Ω
Go to Step 14 Go to Step 15
Go to Step 14 Go to Step 15
Go to Step 14 Go to Step 15
Go to Step 14 Go to Step 15
-
System OK
-
System OK
Value(s)
Yes
-
Go to Step 3
Go to Step 3
-
System OK
-
Go to Step 4
Go to Step 4
No
-
-
-
-
-
No
Go to Step 2
Go to Step 2
-
Go to Step 5
Go to Step 5