Tabla de contenido
Publicidad
CLUTCH DISC AND RELATED COMPONENTS Tools
Required
J-36547 Input shaft seal installer J-42474
Clutch Arbor
Removal and Installation Procedure
1. Disconnect the negative battery cable.
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
2. Raise and suitably support the vehicle.
3. Remove the left front wheel. Refer to
3. Remove the left front wheel. Refer to
3. Remove the left front wheel. Refer to
4. Remove the engine under covers. Refer to
4. Remove the engine under covers. Refer to
4. Remove the engine under covers. Refer to
5. Remove the transaxle from the vehicle. Refer to
5. Remove the transaxle from the vehicle. Refer to
5. Remove the transaxle from the vehicle. Refer to
6. Remove the pressure plate bolts and the pressure plate. Support the pressure plate when you remove the last
6. Remove the pressure plate bolts and the pressure plate. Support the pressure plate when you remove the last
bolt.
Adjustment Notice :
Coat the spline on the clutch disc with multi-purpose grease.
Coat the spline on the clutch disc with multi-purpose grease.
o
o
Align the pressure plate and the clutch disc onto the flywheel using the clutch arbor J-42474.
Align the pressure plate and the clutch disc onto the flywheel using the clutch arbor J-42474.
o
o
Installation Notice
Section 2E, Tires and Wheels.
Section 2E, Tires and Wheels.
Section 2E, Tires and Wheels.
Section 9N, Frame and Underbody.
Section 9N, Frame and Underbody.
Section 9N, Frame and Underbody.
Section 5B. "Five-Speed Manual Transaxle".
Section 5B. "Five-Speed Manual Transaxle".
Section 5B. "Five-Speed Manual Transaxle".
Tightening Torque
15N•m (11lb-ft)
Publicidad
Tabla de contenido
