Daewoo Nubira Manual De Taller página 1877

Check for a worn release bearing.
Check for an improperly installed release lever.
Check for binding in the linkage or the release bearing.
Check for weak pressure plate springs.
Check for binding in the linkage.
Check for a worn driven plate.
CLUTCH PEDAL
(Left-hand Drive Shown, Right-hand Drive Similar) Removal
and Installation Procedure
1. Disconnect the negative battery cable. 1. Disconnect the negative battery cable.
Checks
Pedal Stays on Floor When Disengaged Checks
Checks
REPAIR INSTRUCTIONS
ON VEHICLE SERVICE
Replace the worn release bearing.
Remove and properly reinstall the fork shaft. Very lightly lubricate the fork
fingers at the release bearing with wheel bearing grease.
Lubricate and freeup the binding linkage or the release bearing.
Replace the pressure plate.
Hard Pedal Effort
Lubricate and free-up the binding linkage.
Replace the worn driven plate.
Action
Action
Action