Tabla de contenido
Publicidad
4. Adjust the clutch pedal travel. Loosen the locknut and turn the bolt. Clutch pedal travel should measure more
4. Adjust the clutch pedal travel. Loosen the locknut and turn the bolt. Clutch pedal travel should measure more
than 130 mm (5.1 inches). Tighten the locknut after adjustment.
CLUTCH RELEASE POINT ADJUSTMENT (HYDRAULIC) Adjustment
Procedure
1. Apply the parking brake.
1. Apply the parking brake.
2. Run the engine at idle speed.
2. Run the engine at idle speed.
3. While you move the shift lever into the reverse position, depress the clutch pedal slowly and measure the
3. While you move the shift lever into the reverse position, depress the clutch pedal slowly and measure the
distance between the point when gear noise is not heard and the point the clutch pedal is completely depressed. The distance
should be more than 30 mm (1.2 inches).
4. If the distance is not more than 30 mm (1.2 inches), check the following:
4. If the distance is not more than 30 mm (1.2 inches), check the following:
Clutch pedal height
Clutch pedal height
o
o
Clutch pedal play
Clutch pedal play
o
o
Air in the system
Air in the system
o
o
Clutch cover and disk
Clutch cover and disk
o
o
Publicidad
Tabla de contenido
