Tabla de contenido
Publicidad
3. Remove the bearing-adjusting ring using the remover/installer KM-520.
3. Remove the bearing-adjusting ring using the remover/installer KM-520.
Installation Notice
Tightening Torque
Tighten or loosen the bearing ring adjuster to get the required preload on the bearings.
Tighten or loosen the bearing ring adjuster to get the required preload on the bearings.
o
o
Used Bearings:
Used Bearings:
o
o
1 N•m (9 lb-in) required to rotate the differential one revolution per second.
New Bearings:
New Bearings:
o
o
2 N•m (18 lb-in) required to rotate the differential one revolution per second.
4. Remove the right-side bearing-retainer bolts and the right-side bearing retainer.
4. Remove the right-side bearing-retainer bolts and the right-side bearing retainer.
Installation Notice
Tightening Torque
Used Bearing
New Bearing
1 N•m (9 lb-in)
2 N•m (18 lb-in)
25 N•m (18 lb-ft)
Publicidad
Tabla de contenido
