Tabla de contenido
Publicidad
1. With the vehicle on a level surface and the fluid in the transaxle cold, Remove the filter plug and check the
1. With the vehicle on a level surface and the fluid in the transaxle cold, Remove the filter plug and check the
fluid level. the fluid should come to the bottom edge of the plughole.
2. If the level is low, add SAE 80 manual transaxle fluid through the filter plughole until the fluid begins to run
2. If the level is low, add SAE 80 manual transaxle fluid through the filter plughole until the fluid begins to run
out.
3. Reinstall the filter plug and tighten it securely.
3. Reinstall the filter plug and tighten it securely.
The speed gears and the synchronizer parts on this vehicle receive lubrication through specific passages in the mainshaft.
It takes 1.9 liters (2.01 quarts) to fill the transaxle completely.
Publicidad
Tabla de contenido
