Connections; Connectors On The Back; Circuit Fuses; Mains Connection - CooperSurgical K-SYSTEMS L100 Serie Manual De Instrucciones

INSTRUCTION MANUAL FOR K-SYSTEMS L100 SERIES WORKSTATIONS (English)
8

CONNECTIONS

The L100 Workstations have connections on the back and inside.
8.1

Connectors on the Back

On the back of the workstation there are 8 circuit fuses, a main connector, a main switch, a mains fuse,
and the gas inlet.
In the following sub-sections, the connectors are explained in more detail.
NOTE: To replace the fuses, unplug the workstation and use a suitable screwdriver.

8.1.1 Circuit Fuses

This equipment is protected by fuses. The fuse ratings are printed on the label attached next to each fuse
holder (See Section 10: Fuses).
NOTE: Note that some of the fuse holders may be empty due to various confi guration possibilities. Only
replace with same type fuse.

8.1.2 Mains Connection

Mains are connected with the cable supplied with the unit. If this is not present or does not fi t, contact
your local Service Representative. Do not use a non-original cable, this could be dangerous and will void
the warranty.
Before connecting the mains, check the markings on the side of the workstation and verify that the yellow
mains label refl ects the correct voltage.
When marked 220-240 V AC, the workstation can be connected to mains in the range of 220-240 V AC
50-60Hz.
If the markings correspond with the local mains power the unit can be connected and switched ON.
115 V
FS1 6.3 A
FS2 6.3 A
FAN1 2 A
FAN2 2 A
LIGHT 0.5 A
TRANF 4 A
AUX 6.3 A
• FAN2 is only used for the L126 Workstation.
• The L126 Dual requires an additional transformer.
• AUX is only used if monitor or power plug is installed.
36
230 V
6.3 A
6.3 A
2 A
2 A
0.5 A
2 A
4 A