Publicidad
Idiomas disponibles
Idiomas disponibles
multipiezo
Item
Scaler Handpiece
Front cone for LED handpiece
Light guide kit
Front cone without light
Peristaltic pump rotor assembly
Table 4 – Accessories available for separate order.
b) Produced by Mectron.
c) Distributed by Mectron.
The packaging of the appliance cannot
undergo strong impacts as contains electronic
components, therefore the transport and the
storage must be carried out with particular
care.
Do not stack various boxes in order to avoid
pinching the underlying packaging.
All the material sent by MECTRON was
controlled at the time of dispatch.
The
appliance
is
shipped
protected and packaged.
Upon receipt of the appliance, check for any
12
Accessories available for separate order
Code
MANIPOLO ABLATORE LED (LED
03120142
SCALER HANDPIECE)
Front cone for LED SCALER
03020158
HANDPIECE
Front cone, light guide and
02900146
decorative ring for SLIM scaler
handpiece
Front cone for LED SCALER
03020171
HANDPIECE
03020226-
c)
001
appropriately
Description
b)
b)
b)
b)
d) To be used only for ME type inserts.
e) To be used only for the "Crown Preparation" kit.
possible damage caused during transport and
in case any damage and/or defects is found,
complain to the transporter.
Keep the packaging in case any items need to
be sent to an Authorised MECTRON Service
Centre and to store the appliance during long
periods of non-use.
WARNING: Before starting the treatment,
always make sure to have a stock of material
(handpiece, inserts, wrenches) to use in the
event of failures or drawbacks.
Ref.
M
N
P
G
O
Publicidad
