Publicidad
ENGLISH
3.7 FOLDING FRAME
The seeder is suitable only for the uses indicated. Any other
use different from that described in these instructions could
cause damage to the machine and represent a serious hazard
for the user.
Regular operation depends on the correct use and adequate
maintenance of the equipment. It is advisable therefore to observe
scrupulously what is described in order to prevent any inconve-
niences that could prejudicate proper operation and duration. It is
just as important to keep to what is described in this booklet since
the Manufacturer declines all responsibility due to negligence
and non-observance of these rules.
At any rate the Manufacturer is available to assure immediate and
accurate technical assistance and all that may be necessary for
the improved operation and better performance of the equipment.
Check that the quick hook-ups are coupled correctly; parts of
the system could get damaged if they are not.
ATTENTION
Oil escaping at high pressure can cause skin injury with the risk of
serious wounds and infection. Call a doctor immediately if such an
incident occurs. Therefore, the installation of hydraulic components
in the tractor driver's cab is strictly forbidden.
All the components of the system should be positioned carefully to
avoid parts being damage during use of the equipment.
52 - EN
USE AND MAINTENANCE
3.7.1 DESCRIPTION OF FUNCTIONING
The machine frame is designed so that the side ends that hold the
planting elements can be folded using a hydraulic system (Fig.14),
thus reducing the road.
The hydraulic folding parts of the planter are fl oating and allow you
to work on ground that is not perfectly fl at. The side parts of the
frame, in fact, can move down with respect to the central one by
approx. 7 centimetres (Fig. 15).
They are moved by double-acting hydraulic cylinders, independen-
tly of each other. To adjust the speed of rise and fall of the side
frames it is necessary to adjust the valve located on each hydraulic
delivery pipe, as explained in chapter 3.1. (Fig. 10).
When opening and closing of the folding frame, do not under
any circumstances stand close to the machine.
In order to use correctly the toolbar of the planter, operate as
follows:
1) Hook the planting unit to the tractor three-point coupling using
suitably sized pins equipped with the necessary safety devices
(retainer clips, spring pins, etc.).
2) Connect the planting unit hydraulic pipes to the tractor distri-
butors (see chapter 3.1).
3) Before switching the machine on, make sure that there are no
people, children, animals or any object that could get in the
way of the machine, and ensure that there is excellent visibility
in the area of operation.
DANGER
cod. G19502812
fi g. 14
fi g. 15
Publicidad
