Publicidad
5.0.9 REPLACING THE SEED PLATE
All operations described in this paragraph must be carried
out by expert personnel, equipped with protective gloves, in
a clean and dust-free environment.
- The seeder must be clean and dry and stably positioned.
If the power take-off is hooked to the tractor it must be di-
sconnected, the engine turned off, the key removed and the
hand brake pulled.
- Only clean parts in good condition must be installed.
- The disk must be assembled with the hole countersink turned
towards the distributor cover.
- If there are circular scratches, they must not exceed 1/3 of
the plate thickness.
N.B. When replacing worn plates, the cover gasket should
also be replaced.
REPLACING THE COVER SEAL
Check the whole of the seed distributor cover seal surface
regularly (A, Fig. 59) for signs of wear.
The seal must be replaced before the surface «A» (Fig. 59), being
worn down by the disc movement, reaches surface «B». Also check
that no grooves have been made by the disk along surface «A».
A
B
cod. G19502812
CAUTION
B
USE AND MAINTENANCE
6.0 DEMOLITION AND DISPOSAL
This operation is to be carried out by the customer.
Before demolishing the machine, you are advised to carefully check
its physical condition and ascertain whether there are any parts
of the structure that may be susceptible to structural collapse or
breakage during demolition.
The customer should operate in compliance with the environment
protection laws in force in his/her country.
The machine demolition operations should be carried out
by skilled personnel only, equipped with suitable protective
clothing (safety footwear and gloves) and auxiliary tools and
equipment.
All the disassembly operations for demolition should be carri-
ed out with the machine stopped and detached from the tractor.
Before demolishing the machine, you are advised to render
harmless all the parts that may be a source of danger and
therefore:
- scrap the structure using specialized fi rms,
- remove any electrical apparatus according to the laws in
force,
- collect oils and greases separately, to be disposed of through
specialized fi rms, in accordance with the regulations of the
country in which the machine was used.
When the machine is demolished the CE mark should be
destroyed together with this manual.
A
fi g. 59
ENGLISH
CAUTION
EN - 77
Publicidad
