TOHATSU MFS 4C Manual Del Propietário página 37

36
ENGINE OPERATION
ENOW00049-0
WARNING
Do not put hand or finger in between
outboard motor body and clamp bracket
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to
disconnect fuel hose or close fuel cock,
or fuel may leak, potentially catching
fire.
ENOW00050-0
CAUTION
Do not tilt up outboard motor during opera-
tion, or engine may be damaged from over-
heating due to lack of sufficient cooling
water.
ENOM00425-0
9. Shallow water operation
ENOW00051-0
WARNING
During shallow water operation, be careful
not to place your hand between the swivel
bracket and the stern bracket.
Be sure to tilt the outboard motor down
slowly.
ENON00019-0
Note
Slow down to trolling speed, and shift into
neutral before setting outboard motor to
shallow water drive position.
ENOW00052-0
WARNING
Run at lowest possible speed when
using shallow water drive.
Tilt lock is disabled when in shallow
water drive position.
When driving shallow water, be careful
not to strike outboard motor against sea
bottom, or propeller may be pushed out
of water, resulting in loss of control.
ENOW00053-0
CAUTION
While in shallow water drive position, do
not operate the outboard motor in Reverse.
Operate the outboard motor at slow speed
and keep the cooling water intake sub-
merged.
ENOM00426-0
Shallow water running position
With the shift lever in Forward, tilt the
motor up slowly, to approximately 40°,
then lower the motor it will automatically
set in the shallow water operation angle.
ENOM00427-0
Tilt down from shallow water running
position
Tilt the motor up, approximately 15°, and
pull the tilt lever toward you then lower the
motor slowly to the normal running posi-
tion.
1. Tilt lever
2. Tilt stopper
1
2
ENOF00443-0