TOHATSU MFS 4C Manual Del Propietário página 52

1. Oil plug (Upper)
3. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENON00404-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 195 mL (6.6
fl.oz.).
ENOM00100-0
3. Off-season storage
Before you put your outboard motor in
storage, it is a good opportunity to have it
serviced and prepared by your dealer.
ENOW00096-0
CAUTION
Before servicing the motor for storage:
 Remove the battery cables.
 Remove the spark plug caps from the
spark plugs.
 Do not run the motor out of the water.
ENOM00435-0
Engine
1. Wash the engine exterior and flush the
1
2. Use a dry cloth to completely wipe off
ENOF00457-0
3. Drain all fuel from the fuel hoses, fuel
4. Remove the spark plugs and spray
5. Change the engine oil.
6. Change the gear oil in the gear case.
7. Apply grease to the propeller shaft.
8. Apply grease to all sliding parts, joints,
9. Stand the outboard motor up vertically
ENOW00097-0
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
dance with local fire prevention and
environment protection regulations.
INSPECTION AND MAINTENANCE
cooling water system thoroughly with
fresh water. Drain the water com-
pletely.
Wipe off any surface water with an oily
rag.
water and salt from the electrical com-
ponents.
pump, and carburetor, and clean these
parts.
Keep in mind that if gasoline is kept in
the carburetor for a long time, gum and
varnish will develop, causing the float
valve to stick, restricting the fuel flow.
storage oil (available from an autho-
rized dealer) into the combustion
chamber through the spark plug holes
while slowly turning the motor over
using the recoil starter.
nuts, and bolts.
in a dry place.
WARNING
51