General Safety And Installation Instructions - Waeco magic speed MS-50 Instrucciones De Montaje

INSTALLASJON AV VAKUMSERVOMEKANISMEN, MONTERINGSMULIGHETER
Mulighet 1 (se C 2):
Montering på den eksisterende, eller en ekstra montert (B 6) gasstag.
Bowden-kabelen til MS 50 festes ved hjelp av den dreibare bolten. Hvis
gasspedalen bejenes manuelt, glir Bowden-kabelen til MS 50 gjennom
bolten.
Mulighet 2 (se C 3):
Montering på en eksisterende Bowden-kabel. Bowden-kabelen til MS 50
festes ved hjelp av klemblokken som er forbundet med gass-wiren. Hvis
gasspedalen bejenes manuelt, glir Bowden-kabelen til MS 50 gjennom
klemblokken.
BOWDEN-KABELFESTE
Se D 1 til E 1.
MONTERING I KJØRETØY UTEN GASS-WIRE
Se E 2.
VAKUUMSERVOENHET - VAKUUMTILSLUTNING (SE
Vakuumslangen skal alltid skjæres over mellom tilbakeslagsventil og
innsugningsmanifold eller vakuumpumpe (på motorsiden)
1. Skjær vakuumslangen over mellom tilbakeslagsventil og
innsugningsmanifold eller vakuumpumpe (på motorsiden).
2. Sett inn et passende T-sykke (B 44, B 45, B 48) mellom de avskårne
vakuumslangene, og sikre dem med slangeklemmer.
3. Koble sammen vakuumservoenheten og tilkoblingene til T-stykkene med
vakuumslangen (B 47).
206
Book_MS-50_A6.p65 39

3.0 GENERAL SAFETY AND INSTALLATION INSTRUCTIONS

Warning! Due to risk of short circuits, always disconnect the
negative pole of the battery before starting work.
In the case of vehicles with a supplementary battery, also
disconnect this negative pole.
Warning! Improper cable connections may result in short circuits
which can cause:
- cable fires
- triggering of the airbag
- damage to electronic control equipment
- failure of electrical functions
(blinkers, brake lights, horn, ignition, lights).
Please note the following:
For working on the cables, the following terminal designations are used:
30 (input from battery plus direct)
15 (switched plus, behind battery)
31 (return cable from battery, neutral)
Use only insulated cable brackets, connector plugs and tabs. Do not use
crimp connections (cable connectors) or lustre terminals. The securest form
of connection is by soldering the cable ends and then insulating the
connection.
For connecting the cables use crimping pliers
E 3)
For cable connections to 31 (earth):
Attach the cable with a bracket and toothed washer to an earthing screw
on the vehicle or screw it onto the metalwork of the vehicle using a
bracket, metal screw and
Always ensure a good earthing connection!
Caution! When disconnecting the negative pole of the battery, all
the volatile memories of the convenience electronics lose their
stored data.
10-02-2003, 11:11
toothed washer.
39