Turning Bluetooth On The Prosthesis On/Off; Switching Bluetooth Off/On Using The Cockpit App - Ottobock Genium-Bionic Prosthetic System 3B1 Instrucciones De Uso

Parameter
Locking angle
Pitch
Volume

8.3 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 87).
INFORMATION
Basic mode (mode 1) has to be active to turn off Bluetooth. If a MyMode is activated, one has to
switch to basic mode to turn off Bluetooth.

8.3.1 Switching Bluetooth off/on using the cockpit app

Switching off Bluetooth
1) When the component is connected, tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Deactivate Bluetooth".
4) Follow the on-screen instructions.
Switching on Bluetooth
1) Turn the component over or connect/disconnect the battery charger.
Adjustment Setting
software range, app
range
0–90 +/- 10
1000 Hz– 1000 Hz–
4000 Hz 4000 Hz
0–4 0–4
Meaning
Angle up to which the knee joint can
be extended.
Information: If this parameter is >0,
the knee joint is locked in a flexed
position in the extension direction. To
unlock it, unload the prosthesis and
tilt it back for at least 1.5 seconds.
This makes extension of the joint pos­
sible independently of the settings for
the parameters "Basic ext." and
"Locking angle". This may be neces­
sary to switch to basic mode using a
movement pattern.
Pitch of beep signal for confirmation
tones
Volume of beep signal for confirma­
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud­
ible feedback signals. However, warn­
ing signals in case of errors are still
generated.
87