Publicidad
Rethreading
the Serger
Threading
the lower looper
Open the looper cover.
Place the spool of thread on the right side spool pin..
o Lower looper threading points are marked in green,
, There is a convenient threading chart located on the
machine body behind the looper cover
(_ Thread guide
(_ Thread guide plate
(_ Looper thread guide
(&) Lower looper thread tension dial
(_) Lower looper thread guide 1
(_ Lower looper thread guide 2
O Lower thread take-up lever
Lower looper thread guide 3
(_ Lower looper thread guide 4
@,_ Lower looper thread guide 5
@ Lower looper
NOTE:
if you remove the needle plate (page 92), the threading
points of lower looper are easier to see. Make sure the
thread is not caught by the needle plate when replacing
the plate after threading,
[] Draw the thread through the far right side thread
guide (_ from back to front.
Thread guide
• If the thread slips out from the thread guide groove while
serging, pass the thread through the thread guide hole as
shown.
[] Pass the thread through the far right holes in the thread
guide plate as illustrated
(_) Thread guide plate
[] Pass the thread through the right side of the looper
thread guide, sliding the thread from left to right.
(_) Looper thread guide
[]
f-
[]
k.
f
[]
24
J
J
Publicidad
Capítulos
