Descargar Imprimir esta página

Threading The Right Needle - Sears Kenmore 385.16622 Manual De Instrucciones

Publicidad

Threading
the right
needle
Place the spool of thread on the spool pin second from the
lefto
Right needle threading points are marked in blue_
There is a convenient threading chart located on the
machine body behind the looper cover.
(_ Thread guide
(_ Thread guide plate
(_ Right needle thread tension dial
Right needle thread guide
(_ Thread take-up lever cover
(_ Needle thread guide
_) Needle bar thread guide
(_ Right needle
m Draw the thread through the thread guide second from
the left from back to front,
(_ Thread guide
• If the thread slips out from the thread guide groove while
serging, pass the thread through the thread guide hole
as shown.,
[] Pass the thread through the second set of holes on the
thread guide as illustrated..
(_ Thread guide plate
[] Insert thread between the tension discs,
Hold the thread at both ends and tug gently to ensure
the thread is fully inserted between the tension
discs°
(_ Right needle thread tension dial
[] Turn the handwheel toward you to bring the needle bar to
its highest position, then pass the thread through the right
needle thread guide and the thread take-up lever cover.
(_ Right needle thread guide
(_ Thread take-up lever cover
[] Pass the thread through the needle thread guide sliding
the thread from left to right,
Needle thread guide
[] Pass it through the needle bar thread guide from left to
right.
(_ Needle bar thread guide
[] Thread the right needle from front to back and pull the
thread about 4""(10 cm) from the eye of the needle to the
back,,
(_) Right needle
f
[] Q
21ZII
f
[]
f
%@[][][]
=
®
®
J
34

Publicidad

loading